Installing a Landscape Lighting Transformer

!±8± Installing a Landscape Lighting Transformer

One of the most important steps for the installation of low voltage outdoor lighting is always the correct installation of your landscape lighting transformer. However, this is a step that many people do not have enough time and, as a result of confusion. Here are some steps on how the group transformer, transformer or power you need for your outdoor lights to make sure that the lighting low voltage exactly as it was planned to install look.

The first step in the installationany transformer lighting is to figure out where to put it. You need two things for an ideal transformer installation - easy access to an external waterproof socket and close access to your lights. Most houses have some taken outdoors, but if you have one that is too far from the lights, you must call in some circumstances in a professional electrician to wire to the nearest one to you.

The reason for this is that you have installed an electric cablefarther from the source, the total amount of current in the line decreases by one part of it actually lost the cable. This is not a very big problem with the normal household waste electric lines, because they contribute to 120v power. The loss of a volt or two or five of these is unlikely to have any effect. But with low-voltage cable, you only need to work with 12v. A few volts loss of even a significant difference in how bright the lights are and if they are actually at workall!

If you can not get the transformer is close enough, you must have lights for the tension that carries the line. Sixteen to 22 volts is still considered generally safe for use as low voltage lighting.

Once the transformer is close enough to get the lighting, the only thing to do even more for you to mount the transformer. It should be mounted on the side of your house or on a post that protrudes from the floor. While yourTransformer will be weatherproof, yet do not want it to sit in standing water. Sitting in water and mud long enough to go to that end and you have to short circuit and a new one. Avoid this by mounting the transformer a few minutes.