Your oil burner does not light up and checking it turns out that the transformer does not make the necessary spark to ignite the burner. A change to this part is not difficult. I'd give some tips on how this can be done easily.
To check in a fast ignition transformer, loosen the screws that hold it and push the small lever again. To start after pressing the reset button for the engine to wait. Once the engine is running, unplug it and feel a little 'to jump the spark to the electrodes. This spark is usually very hot and has an area of at least ¼ to jump. "If a lazy yellow / orange sparks instead of a light blue / white sparks are hot, or if there is no spark at all, then you need the transformer. Replace
To change the transformer turn on the burner and turn to open the transformer. There are two screws holding the hinge on the back of the transformer. Remove the junction box and the protectorelaydisconnect the cables of the transformer. Remember where these lines so that they are to go back to the same place.
Mount the new transformer in place with two screws and connect the cable to the right place. Turn the power back on and try to fire the burner. The reset button on protectorelay you may need to be postponed again. If the burner does not light enough, you also have other problems. You must continue to resolve the problem or call professionalto help.
It is not uncommon for oil burners and problems in bundles for more than one party is not all at once. Do not be discouraged if there are several problems. This is quite normal with oil burners. Be patient and methodically check each component and replace if necessary.
Oil burner repair can be challenging, but there are many things you can do when you have some mechanical knowledge. Have fun and good!
No comments:
Post a Comment